Build your own Foosball Table - The sides

< Sides I | Sides II | Body >

Back to table of contents

The holes for the bearings are drilled with a 25mm router bit. If you have no router at hand, you can also use an electric drill with a 25mm Forstner bit. Here we have to be very careful and make sure that all holes are drilled truly plumb so that afterwards the rods do not stick.

Finally, by means of a 45° carried router, we will fit all exteriors both the one of the ball feed as the one of the ball slide, with a strong cant.

< Sides I | Sides II | Body >

Back to table of contents